Tandberg Data DPS Expansion Module Disk Pack Especificações descarregar pdf (Página 36)

30 | Installing and Configuring Additional Enclosures

4. Power on DPS1000 Series.

5. Power on all connected DPS Expansion Module enclosures.

To add an XDS1200a-1 expansion enclosure

1. Shut down DPS1000 Series from its web interface and power off any connected DPS

Expansion Module enclosures.

2. Install and cable the DPS Expansion Module expansion enclosures to the DPS Expansion

Module controller enclosure and one another. Refer to Unpacking and Cabling DPS

Expansion Module on page 3.

3. If you are installing an expansion enclosure with 12 drives, create two arrays. If you are

adding an expansion enclosure with six drives, create one array. Refer to Creating arrays

on page 30.

Alternately, you can create a set of hot spares from six drives. Refer to Designating hot

spares on page 33. If you create hot spares, skip to step 5.

4. Create a logical drive for each array. Refer to Creating logical drives on page 32.

5. Power on DPS1000 Series.

6. Power on all connected DPS Expansion Module enclosures.

Note

When you connect a new DPS Expansion Module expansion enclosure to DPS1000

Series, DPS1000 Series will quickly start moving data to it to balance all DPS1000

Series storage. As a result, DPS Expansion Module may be busy soon after it is

powered on.

Creating arrays

You must configure arrays for any DPS Expansion Module expansion enclosures and their

drives or sets of drives shipped separately from the DPS Expansion Module controller

enclosure.

To create an array

1. On the main page of the DPS Expansion Module web interface, click Create Array.

2. In the Performance Profile drop-down list, ensure that General is selected.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sem comentários

Tandberg Data DPS Expansion Module Disk Pack Especificações Página 36